This could be due to hardware conflicts.

I would first suggest you to run the hardware and device troubleshooter and check if that helps.

Refer to the link:



Step 1:

I suggest you to try to boot the computer in safe mode and check, Please refer to the below Microsoft article and check if it helps.


Step 2:

I suggest you to perform clean boot and check, using this Microsoft Article because may be a third party application is causing this issue.


NOTE: A clean boot is performed to start Windows by using a minimal set of drivers and startup programs. This helps eliminate software conflicts that occur when you install a program or an update or when you run a program in Windows. You may also troubleshoot or determine what conflict is causing the problem by performing a clean boot. You must log on to the computer as an administrator to be able to perform a clean boot. Your computer may temporarily lose some functionality when you perform a clean boot. When you start the computer normally, the functionality returns. However, you may receive the original error message, or experience the original behavior if the problem still exists. If the computer is connected to a network, network policy settings may prevent you from following these steps.


Once you perform clean boot do refer to the section “How to reset the computer to start normally after clean boot troubleshooting” to boot the computer in normal mode.


Hope this information helps. Please let us know if you need any other assistance with Windows in future. We will be happy to assist you.

Leave a Reply

Your email address will not be published. Required fields are marked *